#87 A DIY simple 18650 backup ups board
After setting up a CCTV system consisting of multiple WiFi cameras placed over my property I noticed that certain cameras were located in areas far away from AC outlets covered by my backup electrical system.
In this project I used some an old 18650 (LG makes the LGABD11865 ) from a laptop power supply. Also I upgraded my 5v charger to a 1.5A to provide enough charging and running current for the camera. The camera I am using is the EZVIZ C3W 1080p WiFi camera
Since Load-shedding has been increasing dramatically I had the need to find cheap simple and reliable power sources for there cameras (12v DC). One important requirement is that the backup system needs to fit into a small area E.G an electrical box on a pole where the camera is located.
While researching I came across the so called mini dc ups device mainly used for backing up WiFi routers at either 9v, 12v, 15v, 24v. however these devices seemed a bit overkill electronically wise and also price wise.
So I decided to opt-in on a cheaper smaller sized DIY version the components consisting of:
- LiPo charger +DC-DC step-up module here
- suitable PCB board here
- 18650 li-ion battery holder here
- 18650 battery 3500mah here
- 5v cellphone charger micro-usb here
The components are all soldered onto a 50mm x 70mm 1 sided PCB board.
I noticed that the 4056 IC gets quite warm but doesn’t burn my fingers. The same goes for the coil. The specification is max 1A and the load I was applying was around 0.33mA – 0.670mA
After testing this particular LiPo charger PCB I noticed a few major problems the first being that the 8-pin 4056 LiPo chip is a copy of a copy… the next critical problem is that there is no protection circuitry besides the overcharge/discharge function in the 4056 chip.
This is a big problem since the chip does not switch off completely when low voltage occurs and as a result the load will periodically switch on and off unreliably before finally switching off completely. This oscillation can damage the load.
A solution will be to use a separate LiPo PCB with protection mosfets and a separate booster board.
